1 / 2
minimalistic twist dice tube (vase mode) — zdjęcie 1
1 / 2

minimalistic twist dice tube (vase mode)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A twist tube container for dice (DnD set or 6 standard dice) in vase mode - only 26g.

Ocena
4,571 / 5
Polubienia
186
Pobrania
551
Wydruki
8
Wyświetlenia
2383
Oceny
7

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Board Games
Licencja
Creative Commons — Attribution

Inspired by Val's “Twist 7 dices storage” I wanted to make a similar, but minimalistic box in vase mode, using less filament (26g), faster to print (~10x), also smaller to be printable on the Prusa Mini, and without magnets. However, Val's tube with the magnets will probably give a more satisfying operation :)

I also added a version for 6 standard D6 dice (dicetube_6; 21g) and a mini version for a test print (7g). 

Printing tips:

  • vase mode
  • best with 0.4mm nozzle; 0.6mm nozzle might work.
  • advanced → external perimeter: 0.6mm
  • advanced → slice gap closing radius: 0.01mm  ← IMPORTANT
  • inner part: layer height 0.2mm, bottom solid layers: 5 (min 1mm)
  • outer part: layer height 0.17mm, bottom solid layers: 3

I usually tend to speed up case mode printing setting filament settings → cooling → “slow down if layer print time is below:” to, say, 5 seconds; but depending on nozzle size and cooling, this can be too fast for the overhangs at the the top of the openings. Maybe try the small test version first.
 

Tagi