minimalistic twist dice tube (vase mode)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A twist tube container for dice (DnD set or 6 standard dice) in vase mode - only 26g.
- Rating
- 4.571 / 5
- Likes
- 186
- Downloads
- 551
- Makes
- 8
- Views
- 2,383
- Reviews
- 7
Updated at source:
Model information
- Source
- Printables
- Category
- Board Games
- License
- Creative Commons — Attribution
Inspired by Val's “Twist 7 dices storage” I wanted to make a similar, but minimalistic box in vase mode, using less filament (26g), faster to print (~10x), also smaller to be printable on the Prusa Mini, and without magnets. However, Val's tube with the magnets will probably give a more satisfying operation :)
I also added a version for 6 standard D6 dice (dicetube_6; 21g) and a mini version for a test print (7g).
Printing tips:
- vase mode
- best with 0.4mm nozzle; 0.6mm nozzle might work.
- advanced → external perimeter: 0.6mm
- advanced → slice gap closing radius: 0.01mm ← IMPORTANT
- inner part: layer height 0.2mm, bottom solid layers: 5 (min 1mm)
- outer part: layer height 0.17mm, bottom solid layers: 3
I usually tend to speed up case mode printing setting filament settings → cooling → “slow down if layer print time is below:” to, say, 5 seconds; but depending on nozzle size and cooling, this can be too fast for the overhangs at the the top of the openings. Maybe try the small test version first.