Simple Raspberry Pi touch screen case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple case for a Raspberry Pi with the official 7 inch touch screen.
- Ocena
- 5 / 5
- Polubienia
- 20
- Pobrania
- 288
- Wydruki
- 1
- Wyświetlenia
- 2493
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Share Alike
This is a simple case for a Raspberry Pi (any version) with the official LCD touchscreen from the Raspberry Pi Foundation.
Parts needed:
- 4 x 3mm thread inserts
- 4 x screws for the LCD screen
- 4 x M3x6mm screws (back lid)
The screws can be welded to the included knobs, or flat head screws can be used.
Print settings and instructions:
Easy to print, without supports. If printing in higher speeds, use a small brim to avoid warping with the big flat pieces.
All parts can be printed without support, using the correct orientation.
- Screen frame: print with the flat side to the bed.
- Case: print with the tabs touching the bed.
- Back lid: print with the tiny screw chamfers facing up.
- Stand: print facing up, with the flat grid to the bed.
Infill: from 8% to 15% is enough. Grid pattern fits better with the flat top layers.
Suggested 3 walls and at least 3 top and bottom layers.
Ironing can make the back lid look better. The other parts do not exposed top layers.
Assembly:
- Put the LCD screen into the frame
- Align the case and fasten everything with the screws included with the LCD screen
- Connect the power lead to the RPi
- Fasten the back lid with the screws / knobs
Attribution: knurled knobs
For the knurled knobs I used a template created by Jim Bixby, available at OnShape: