CR-6 Filament sensor adapter for MicroSwiss dualgear bowden extruder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Bought the MicroSwiss Dual Gear Bowden Extruder for my CR-6 SE and the filament sensor did not align properly, so…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 29
- Wydruki
- 0
- Wyświetlenia
- 258
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
Bought the MicroSwiss Dual Gear Bowden Extruder for my CR-6 SE and the filament sensor did not align properly, so created this.
Designed in Fusion360.
Can probably use the same screws that holds the filament sensor originally, but I used shorter ones.
Is a tight fit for the filament sensor itself, so it does not require any screws.
There is made a hole for the contact of the filament sensor.
Are also a hole in the bottom of the adapter so one can use something to push the filament-sensor back out if needed.
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
15%
Filament: Smartfil PLA Black Post-Printing =============
Notes for assembly
You might want to check the overhangs for the holes for the filament so it is not sagging. Use a tool to even out the holes before assembly.
1. Assemble the adapter with the screws. 2. Assemble the base part of the extruder so that the ptfe-tube goes inside the adapter 3. Cut the ptfe-tube with a exacto knife (or similar) on the inside of the adapter (se picture)4 Push in the filament-sensor.
Category: 3D Printer Accessories