CR-6 Filament sensor adapter for MicroSwiss dualgear bowden extruder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Bought the MicroSwiss Dual Gear Bowden Extruder for my CR-6 SE and the filament sensor did not align properly, so…
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 29
- Makes
- 0
- Views
- 257
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution
Bought the MicroSwiss Dual Gear Bowden Extruder for my CR-6 SE and the filament sensor did not align properly, so created this.
Designed in Fusion360.
Can probably use the same screws that holds the filament sensor originally, but I used shorter ones.
Is a tight fit for the filament sensor itself, so it does not require any screws.
There is made a hole for the contact of the filament sensor.
Are also a hole in the bottom of the adapter so one can use something to push the filament-sensor back out if needed.
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
15%
Filament: Smartfil PLA Black Post-Printing =============
Notes for assembly
You might want to check the overhangs for the holes for the filament so it is not sagging. Use a tool to even out the holes before assembly.
1. Assemble the adapter with the screws. 2. Assemble the base part of the extruder so that the ptfe-tube goes inside the adapter 3. Cut the ptfe-tube with a exacto knife (or similar) on the inside of the adapter (se picture)4 Push in the filament-sensor.
Category: 3D Printer Accessories