Test lead / cable hanger for HDX wire shelving
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Modular test lead hanger that clips onto the outside of HDX wire shelving (or any other shelving with 7/16" tubing).
- Ocena
- 5 / 5
- Polubienia
- 6
- Pobrania
- 56
- Wydruki
- 1
- Wyświetlenia
- 484
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Share Alike
All of the test lead hangers I've seen so far want to be mounted on a wall, and give you a fixed quantity of slots to hang cables from. I wanted to customize how many slots I got, and I wanted to attach it to some wire shelving that I have, so I modeled this up. It clips to the edge of some HDX wire shelving, and hangs off the side; you can clip it either to the front or to the side. My wire shelving seems to use 7/16" main tubing, and this attaches with a satisfying “click!” to that. A dovetail joint on the back provides lateral support between neighboring hangers.
I managed to cram 12 of these on a build plate on my Bambu X1 Carbon. I used some Hatchbox PLA but I'm sure any PLA would probably work fine. There is an obvious orientation to print it in (flat side down); print it like that. My printer seemed to have no trouble with the bridges on default settings at 0.20mm layer height, but if you have a different printer, you presumably know its capabilities better than I do.
Onshape model available at https://cad.onshape.com/documents/638fd74c220d3b96f3d71178/w/50bbb2fc0cccf5ed90223be9/e/ac7409b1f0f20812dc04a035. If I were to do it again I would probably reduce the height a little bit so it actually matches the shelving, but, you know, for now, it is what it is, and it is certainly useful as is.