Pokemon Pokeball tissue box

Originally inspired by the Pokeball planter and the remixes, I made a version as a tissue box holder. This one was modeled from scratch in Fusion 360 and made to have a bit better printability than the planter.

Requirements

• >275mm build area (will not fit on Prusa MK or Prusa Mini printers! Will fit on a Prusa XL)
• Tissue box needs to be less than 235mm x 120mm x 65mm
• Need a weight like M5/M8 nuts

Build instructions

1. Print all parts and 2 x white_button.stl
2. Glue white_button.stl to black_center.stl middle sections with circular inset
3. (Optional) Fill black_center.stl pockets with weights, such as M8 nuts. Fill to the top so that they don't move too much.
4. Apply glue to inside red_top.stl walls and push on top of black_center.stl. It will be a tight fit. Note: The red_top.stl and black_center.stl parts are designed to be a single lid – heavy enough not to move when pulling out tissues.
5. Place tissue box on white_bottom.stl
6. Put top of tissue box over tissues
7. Done!

Print settings

• 0.2mm layer height
• 20% infill
• 150% first layer extrusion width (Optional, helps for printing black_center.stl)
• 4 outer perimeters
• 4 bottom layers and 4 top layers
• No supports required

Updates:

2022-04-06: Increased chamfer on center_black.stl to help reduce elephant's foot