1 / 3
3/8" and 1/2" Skadis Board Ratchet Holder — zdjęcie 1
1 / 3

3/8" and 1/2" Skadis Board Ratchet Holder

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A remix for larger sized ratchets with a stronger hook. -added a 4mm wider version as per request

Ocena
5 / 5
Polubienia
21
Pobrania
164
Wydruki
4
Wyświetlenia
501
Oceny
4

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Organizers
Licencja
Creative Commons — Attribution — Share Alike

A remix of the SKADIS - Ratchet holder by Kenneth Giese Hejnfelt  but for larger sized ratchets with a stronger hook.  Many of the 3/8" sized ratchets would barely fit and there was no hope of getting a ½" drive to fit. By simply up sizing Kenneth's original design and adding a stronger hook this holder will now handle a full sized ratchet with the long handles such as Jet Tool's or a Snap On.

Printed with Rep Rapper's florescent red PLA with the following settings:

Nozzle temp - 213*C

Bed Temp -60*C

Walls - min 5

Supports - Touching bed

 

The original is on the left in the photo's and the larger remix is on the right.

Tagi