3/8" and 1/2" Skadis Board Ratchet Holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A remix for larger sized ratchets with a stronger hook. -added a 4mm wider version as per request
- Rating
- 5 / 5
- Likes
- 21
- Downloads
- 164
- Makes
- 4
- Views
- 501
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Share Alike
A remix of the SKADIS - Ratchet holder by Kenneth Giese Hejnfelt but for larger sized ratchets with a stronger hook. Many of the 3/8" sized ratchets would barely fit and there was no hope of getting a ½" drive to fit. By simply up sizing Kenneth's original design and adding a stronger hook this holder will now handle a full sized ratchet with the long handles such as Jet Tool's or a Snap On.
Printed with Rep Rapper's florescent red PLA with the following settings:
Nozzle temp - 213*C
Bed Temp -60*C
Walls - min 5
Supports - Touching bed
The original is on the left in the photo's and the larger remix is on the right.