Ender 3 V2 Satsana 5015 simplified
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
My personal take on Satsana duct dedicated for Ender 3 V2
- Ocena
- 4 / 5
- Polubienia
- 29
- Pobrania
- 169
- Wydruki
- 2
- Wyświetlenia
- 1428
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution
I found some design decisions regarding original Satsana duct problematic, but being single part, to me it is more appealing than other solutions.
I wanted to achieve following goals with this design:
- Easier mount mechanism
- Your hot-end is now only one screw away!
- You can use any CR/BLTouch mount
- Improved airflow
- Original design had a 90 degree hard turn on one side. It has been smoothed.
- No flimsy leveling sensor held by one screw only with skewed X/Y offsets
- Correct some errors
- Original design left only 14mm for 15mm thick fan which created a gap through which air escaped
- Original had 5015 fan screw holes misaligned
This design can be improved further. Internal air ducts can be smoothed even further and I believe that exhaust should be directed lower for better part cooling.
As installation is based on one screw only, additional bracket from original design is now mandatory to level the duct properly. First make sure that duct is leveled properly, and then tighten screws of additional bracket to keep the angle after repeated mounts.
I left the hole for mounting this into regular Ender 3, but I cannot test it.
PETG/ABS is recommended as I even managed to melt PETG printed part after printing 12h print without part cooling. I imagine that PLA will perform even worse.