Sonicare Toothbrush Upside Down Holder/Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Bathroom wall mount to hold a Sonicare Toothbrush upside down, along with extra brushes and toothpaste.
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 91
- Wydruki
- 0
- Wyświetlenia
- 595
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution — Noncommercial
I wanted a way to get my Sonicare toothbrush off of the counter to save some space and have a cleaner look. I also wanted it to hang upside down so that residual water doesn't drip down over the buttons and onto the base. I generally don't like storing it on the charging base when not charging because water drips onto it and over time it gets dirty. The battery lasts a long time and I usually only charge it once a month anyway.
There are tons of models to mount a Sonicare right-side up, and using the charging base, but none that I found mounted upside down. So I made this to hold the Sonicare upside down, along with 2 extra brushes and room for 2 tubes of toothpaste. I created an open hex pattern on the sides and floor to allow more airflow and prevent water from building up.
I don't like drilling holes in the bathroom wall so I intended for this to be mounted using command strips. I used the velcro command strips so it can be removed easily for cleaning when necessary.
I have the Philips Sonicare HX8911/02 HealthyWhite, though I imagine other similar models will fit as well.
Print Settings
Orient with the back side laying down.
Printer: AnkerMake M5
Filament: PLA+
Infill: 20%
Supports: Yes, I used the organic/tree supports and painted them on in PrusaSlicer just on that one bar where the toothpaste goes since its a long overhang. I attached a picture to show this.
Layer Height: 0.2mm