1 / 5
Patio Umbrella Holder — zdjęcie 1
1 / 5

Patio Umbrella Holder

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Braces designed to hold a patio umbrella against the railing of a deck. I designed it with the Ikea Fliso umbrella in…

Ocena
5 / 5
Polubienia
21
Pobrania
102
Wydruki
1
Wyświetlenia
474
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

Braces designed to hold a patio umbrella against the railing of a deck. I designed it with the Ikea Fliso umbrella in mind, but it can handle any diameter up to 38mm (and pretty much any size below there, thanks to the screw fastener). The screw holes to fasten to the railing are designed to fit #6 drywall screws.

Print Settings

Printer Brand:

TEVO

Printer:

Rafts:

No

Supports:

No

Resolution:

0.2mm

Infill:

50%

Filament: Hatchbox PLA white


Notes:

The tolerance on the front screw fastener are set to a clearance of 0.4mm, pretty generous, but if you print quickly at low-ish resolution, you'll likely need it. The original version had 0.2mm clearance and required a lot of grinding and finishing post-print to function properly

Category: Outdoor & Garden

Tagi