LCR-T4 Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
LCR-T4 Case for original or customized version like mine with ICSP connector from bottom side and micro switch…
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 168
- Wydruki
- 0
- Wyświetlenia
- 1336
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
LCR-T4 Case for original or customized version like mine with ICSP connector from bottom side and micro switch replaced by rotary encoder. ICSP pins are reversed - special cable reduction is required.
Original project: https://www.thingiverse.com/thing:1212733
More info here: https://www.mikrocontroller.net/articles/AVR\_Transistortester
This is remix of: http://www.thingiverse.com/thing:896665
Rottary encoder upgrade:
official project document: https://www.mikrocontroller.net/wikifiles/8/8f/Ttester\_eng111k.pdf
latest firmware: https://www.mikrocontroller.net/svnbrowser/transistortester/Software/trunk/ (folder mega328_T3_T4_st7565)
LCR-T4 schematic: http://www.mikrocontroller.net/attachment/228473/TT-CN\_T4.PDF
German forum: https://www.mikrocontroller.net/topic/248078
Print instructions
Unassociated tags: LCR tester
Category: Electronics Summary
LCR-T4 Case for original or customized version like mine with ICSP connector from bottom side and micro switch replaced by rotary encoder. ICSP pins are reversed - special cable reduction is required.
More info here: https://www.mikrocontroller.net/articles/AVR\_Transistortester
This is remix of: http://www.thingiverse.com/thing:896665
Rottary encoder upgrade:
official project document: https://www.mikrocontroller.net/wikifiles/8/8f/Ttester\_eng111k.pdf
latest firmware: https://www.mikrocontroller.net/svnbrowser/transistortester/Software/trunk/ (folder mega328_T3_T4_st7565)
LCR-T4 schematic: http://www.mikrocontroller.net/attachment/228473/TT-CN\_T4.PDF
German forum: https://www.mikrocontroller.net/topic/248078
Print Settings
Printer Brand: RepRap
Printer: Rebel II
Rafts: No
Supports: No
Resolution: 0.3mm
Infill: 40%
Notes:
Sliced in: Slic3r 1.1.7
Nozzle: 0.4mm
Filament: PLA 1.75mm (http://www.filament-pm.cz/en/)