Braun Multiquick Hand Blender Part Optimized for Prusa i3 MK3S
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Modified Braun Multiquick part
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 112
- Wydruki
- 0
- Wyświetlenia
- 745
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution
I remixed the original gear and optimized it for my Prusa i3 MK3S printer.
I tweaked the physical size of the hole in the bottom of the gear. This fits nice and snug on my blender. The original part came off too easily.
I have also modified the "hat" on the top. It previously had an overhang. I have just modified it to be filled. It increases strength and still fits the mixer perfectly.
Please leave a comment if you successfully make this!
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
Doesn't Matter
Supports:
No
Resolution:
0.1mm
Infill:
100%
Filament:
Generic PET White
Notes:
I found printing it in PET 0.1mm made a nice strong gear.
I did however find that at about the 75% point there is a possibility the model will break away from the bed. Its right on the limits and will depend on your heat bed stickiness. You could always use a raft to be safe but I fixed this by slowing down the printer to about the 75% mark and it seemed to hold on a bit better.