Braun Multiquick Hand Blender Part Optimized for Prusa i3 MK3S
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Modified Braun Multiquick part
- Rating
- 0 / 5
- Likes
- 10
- Downloads
- 112
- Makes
- 0
- Views
- 745
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution
I remixed the original gear and optimized it for my Prusa i3 MK3S printer.
I tweaked the physical size of the hole in the bottom of the gear. This fits nice and snug on my blender. The original part came off too easily.
I have also modified the "hat" on the top. It previously had an overhang. I have just modified it to be filled. It increases strength and still fits the mixer perfectly.
Please leave a comment if you successfully make this!
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
Doesn't Matter
Supports:
No
Resolution:
0.1mm
Infill:
100%
Filament:
Generic PET White
Notes:
I found printing it in PET 0.1mm made a nice strong gear.
I did however find that at about the 75% point there is a possibility the model will break away from the bed. Its right on the limits and will depend on your heat bed stickiness. You could always use a raft to be safe but I fixed this by slowing down the printer to about the 75% mark and it seemed to hold on a bit better.