Tablet/Phone Stand for Wyrmwood MGT (Modular Gaming Table)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This tablet/phone stand is designed to hang your tablet outside the table to maximize play surface. Two are required.
- Ocena
- 4,333 / 5
- Polubienia
- 44
- Pobrania
- 226
- Wydruki
- 2
- Wyświetlenia
- 2568
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution
This stand can be used inside or outside the table, but is designed for the outside. If you are looking for specific sizes/orientations, the tablet_stand.scad file should be able to generate anything you need using OpenSCAD. I can generate a model for you if needed, just let me know what you want to see.
You will need the following hardware to use this print with your table:
- #6x0.5" wood screw (stainless steel recommended) - https://a.co/d/heZ6jlC
- 12mm diameter, 5mm deep countersunk magnet (any polarity) - https://jc-magnetics.com/Magnet-N52-12mm-5mm-Hole-4mm-Countersunk-Ring?search=JCN52-CK12-5-H4
I am mixing imperial and metric hardware here. M3 was just a little thin for the 4mm bore in the magnet, M4 screws were too tight to fit through. #6 screws are around 3.5mm so they fit perfectly.
UPDATE 2023-04-13: The rounded edges made this a little too easy to remove by pulling straight down. The new design has slightly less rounded corners and can support considerably more weight.