Tablet/Phone Stand for Wyrmwood MGT (Modular Gaming Table)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This tablet/phone stand is designed to hang your tablet outside the table to maximize play surface. Two are required.
- Rating
- 4.333 / 5
- Likes
- 44
- Downloads
- 226
- Makes
- 2
- Views
- 2,573
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Other Toys & Games
- License
- Creative Commons — Attribution
This stand can be used inside or outside the table, but is designed for the outside. If you are looking for specific sizes/orientations, the tablet_stand.scad file should be able to generate anything you need using OpenSCAD. I can generate a model for you if needed, just let me know what you want to see.
You will need the following hardware to use this print with your table:
- #6x0.5" wood screw (stainless steel recommended) - https://a.co/d/heZ6jlC
- 12mm diameter, 5mm deep countersunk magnet (any polarity) - https://jc-magnetics.com/Magnet-N52-12mm-5mm-Hole-4mm-Countersunk-Ring?search=JCN52-CK12-5-H4
I am mixing imperial and metric hardware here. M3 was just a little thin for the 4mm bore in the magnet, M4 screws were too tight to fit through. #6 screws are around 3.5mm so they fit perfectly.
UPDATE 2023-04-13: The rounded edges made this a little too easy to remove by pulling straight down. The new design has slightly less rounded corners and can support considerably more weight.