DaVinci 1.0/2.0 fan and hotend shroud
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Completely replaced the stock hotend with a mk8 style hotend (I used and ender 3 and a red lizard V5 )
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 321
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
This is a complete upgrade for a davinci 1.0/2.0 hotend. It has dual part cooling fans and a single 4010 heat break fan.
You will have to relocate the extruder. On the original firmware it will not have part cooling fan support unless you hard wire it. You will have to modify the existing carriage by drilling 2 holes for M3 bolts. The hotend Shou have heat set inserts on the rear and M3 bolts long enough to pass through the holes in the carriage and be bolted on to the carriage. This isn't a beginner upgrade.