3010 fan mount for Voron 0.1/0.2 Kirigami bed
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
3010 Fan mount for Kirigami bed, helps decrease warm up times.
- Ocena
- 4,5 / 5
- Polubienia
- 68
- Pobrania
- 296
- Wydruki
- 3
- Wyświetlenia
- 2436
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution
Inspired by this design, but with single 3010 for the popular kirigami bed. The model isn't pretty but it works well. It would be easier to center the fan but many people use wago connectors and this would not work so I shifted the fan offcenter and angled it 15 degrees forward and 5 degrees toward the center to compensate and allow it to fit easily. I was suprised the fan was as strong as it is, you will probably not be able to run it at full power starting from room temperature so ramping the speed manually or with a macro may be neccessary. It roughly halves the time required to hit 40 C chamber temperature on my 0.2.
Use something that can survive 80+ degrees, it prints well with no supports. You need M3 2 heatset inserts (or nuts and washers) and 2 M3x8 screw to attach the adapter to the bed. The fan is held in place with a further four M3x16 nuts and nuts.