Orange Pi Zero 2 Case with GoPro Mount

This printable case for the Orange Pi Zero 2 can also mount a webcam with your choice of thread or ball attachment. This Pi enclosure case also incorporates the GoPro mount type, so you could use it with similar accessories. It's perfect to place next to, or attach to, a 3D Printer and use with OctoPrint.

Compatibility & Setup:

This Orange Pi Zero 2 case design has been tested with the following. The camera I used is a generic USB Camera.

• Orange Pi Zero2
• Webcam (Generic brand from Amazon)  - This webcam has a tripod thread attachment and you can also separate the camera from the ball joint, to attach to the ball joint on the case.
• USB Splitter Cable for connecting to both Printer and Camera. I used this one from Amazon: Itramax USB Splitter Y Cable 1FT

Features

• Houses Orange Pi Zero2 (No hats)
• Snap-fit case in two parts using holes in PCB
• Uses compatible GoPro mount. Should also work with Module Mounting System by HyVye.
• Ventilation front back and sides
• Adequate space for Easycargo Copper Heatsink 14mm x 12mm x 5mm
• High resolution STL mesh

If anyone finds any problems (dimensionally or otherwise) post them up, so I can fix the model.

Instructions

• Installing OctoPrint
  • If you want to install OctoPrint for 3D Printing with Orange Pi Zero2, then this is an easy-to-follow article (With link to download their Octopi distro): Orange Pi Zero 2 Kit for OctoPrint Setup and Configuration
• Printing
  • Print the Front
  • Choose the Back model depending on whether you want a camera attachment, and it if it's a Thread or Ball type, and print
  • Optional: recommend 5mm Brim
  • Minimum of 3 Wall Lines
• Assembly
  • IMPORTANT WARNING, Remove any SD card from the Pi to prevent damage to the SD card when placing the Pi in the case
  • Place the Orange Pi Zero2 in the case back half, being careful to position the Pi ports in the case holes provided 
  • Gently press the Camera housing into the space provided so it just protrudes out-of-the front of the case
  • Place the front half over the back, gently align PCB holes with the print standoffs.
  • The camera cable will need to bend to fit inside the case
  • Gently press the two halves together until they snap-fit together

Credits

• Orange Pi Zero2 by zhikang wang was used in the mockup render.

EXPERIMENTAL DESIGN 
This model has been designed for a specific use-case, it has not yet undergone extensive testing. Constructive feedback is appreciated.