1 / 5
HORIZONTAL STAND FOR STARSHIP S24/B7
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Vertical stand to proudly display your 3D printed Starship S24 and Booster B7 model.
- Ocena
- 4,714 / 5
- Polubienia
- 201
- Pobrania
- 420
- Wydruki
- 6
- Wyświetlenia
- 4169
- Oceny
- 7
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Physics & Astronomy
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (20)Wydruki i komentarze (Wydruki: 6) (Komentarze: 9)Remiksy (0)Kolekcje (221)Powiązane
Original model
This support is to be used with my starship S24 and the booster B7.
Dimensions and Information
- It is about 6 cm high and 8 cm wide.
- There are 24 pieces to print.
- I printed it in about 5 hours.
Settings
- Infill: 10%
- Support : No
- Raft : No
Printing tips
- If some parts are loose or don't fit you can change the scale by +/- 1% in the slicer to get a better fit.
- For small parts I advise you to print at a very low speed and a high temperature (to reduce the pressure in the nozzle and not to have warping), personally, I printed them at 220° and 5mm/s
- The parts are positioned in the optimal direction for printing.
- For the base, it is recommended to print with 4 perimeters to avoid visible infill.
Post Printing
- You may need to sand the areas where the pieces meet.
- I also advise you to put glue to have a better solidity.
Parts list
