Locking spring for t.bone IEM 200R battery
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement locking spring with snap hooks for the t.bone IEM 200R battery compartment.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 24
- Wydruki
- 0
- Wyświetlenia
- 246
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Music
- Licencja
- Creative Commons — Attribution — Share Alike
The original part broke on the unit of a friend, and he asked me for a replacement. The result fits really well. it's designed so the hooks get printed separately so they are oriented during printing in a way that they will be strong enough to not brake during use.
thomann actual sells the battery compartment as a replacement part for around 10 euros but this way you dont have to wait for the package and you will produce less waste.
Print settings
I would suggest using PETG or a modified PLA that is not as brittle as standard PLA. Extrudr PLA NX2 works fine for example.
It’s a really small part so I used 0.1 mm layer height and 7 perimeters so its consists of only perimeters and no infill areas. It still printed in under 30 minutes. But I am pretty sure 0.2 mm and 3 perimeters will also work with no problems.
Post processing
Glue the hooks in the spring with CA glue, mind the correct orientation.
Mounting in the battery compartment
- remove the 3 screws
- pull the parts apart
- replace the original part with the new one
- put the parts together
- tighten the screws again