1 / 11
Spool shaft for FormFutura & ColorFabb Filament for Mark Wheadon's big spool holder — zdjęcie 1
1 / 11

Spool shaft for FormFutura & ColorFabb Filament for Mark Wheadon's big spool holder

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a shaft for the big spool holder of Mark Wheadonhttp://www.thingiverse.com/thing:761893 I designed it to use…

Ocena
0 / 5
Polubienia
0
Pobrania
10
Wydruki
0
Wyświetlenia
102
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Share Alike

This is a shaft for the big spool holder of Mark Wheadon http://www.thingiverse.com/thing:761893

I designed it to use it with FormFutura filament spools.

Update 2016-01-04: I mentioned that it also fits to ColorFabb's filament!

The outer diameter is 52mm.

The length is 100mm. (v1 - v3)

The length is 115mm. (v4)

The large diameter where the spool is placed is about 65mm in length.

There are 4 versions of it.

  • v1 was the first design
  • v2 was optimized regarding the necessary filament (supports are not symmetric between inner shaft and outer diameter)
  • v3 was optimized to split the printing time (split into two parts, female and male)
  • v4 is the same as v3 but instead of 65mm width or length it is now 80mm, because I got one spool which is 80mm wide

Category: 3D Printer Accessories

Tagi