1 / 11
Spool shaft for FormFutura & ColorFabb Filament for Mark Wheadon's big spool holder
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a shaft for the big spool holder of Mark Wheadonhttp://www.thingiverse.com/thing:761893 I designed it to use…
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 10
- Makes
- 0
- Views
- 102
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Share Alike
This is a shaft for the big spool holder of Mark Wheadon http://www.thingiverse.com/thing:761893
I designed it to use it with FormFutura filament spools.
Update 2016-01-04: I mentioned that it also fits to ColorFabb's filament!
The outer diameter is 52mm.
The length is 100mm. (v1 - v3)
The length is 115mm. (v4)
The large diameter where the spool is placed is about 65mm in length.
There are 4 versions of it.
- v1 was the first design
- v2 was optimized regarding the necessary filament (supports are not symmetric between inner shaft and outer diameter)
- v3 was optimized to split the printing time (split into two parts, female and male)
- v4 is the same as v3 but instead of 65mm width or length it is now 80mm, because I got one spool which is 80mm wide
Category: 3D Printer Accessories