1 / 4
Case for Geekworm X306 UPS shield (18650 battery), RPi Zero W or Zero 2, & Waveshare E-ink Display - Pwnagotchi — zdjęcie 1
1 / 4

Case for Geekworm X306 UPS shield (18650 battery), RPi Zero W or Zero 2, & Waveshare E-ink Display - Pwnagotchi

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Case for Geekworm X306 UPS shield (18650 battery), RPi Zero W or Zero 2, & Waveshare E-ink Display. Pwnagtochi time. :)

Ocena
0 / 5
Polubienia
26
Pobrania
384
Wydruki
0
Wyświetlenia
3245
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I designed this case for the Geekworm X306 UPS shield. It provides constant power via a 18650 Li-Ion battery. You can plug and unplug the USB-C port on the back to charge the battery as needed, without interrupting the operation of the RPi Zero W.

The X306 shield goes in first, USB 2.0 ports angled slightly in until positioned in their slots, then lay it flat. The screws to mount the shield to the case are M2.3*5. Use 2 screws.

Then you mount the RPi Zero W to the shield, and use the screws included with the shield to affix the RPi in place. Use 4 screws. Then mount the e-ink display onto the RPi Zero W via the headers.

There are thin slots on the sides of the case to see the Battery Charge Level (blue LEDs), and the current Power State (Full, Charging, Powered). See video for more details.

There are slots for all other items. USB, HDMI, SD card, etc.

Depending on your printer, you may want to run layers 32-85 at a slower speed (50mm/s vs 250mm/s) to ensure the vertical structures and bridging are printed properly and to reduce post-processing. If you do so, supports should not be needed. 

The print in the pictures/video were done at .20mm with 30% infill.

Excellent for a Pwnagotchi setup. 

You'll notice I put a small bit of Tesa tape around the battery. It makes pulling the battery out much easier as it is a TIGHT fit.

If you have need for modifications to the lid or case let me know.

BOM

More details at my site

Tagi