Laundry Detergent Cup Drainer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A device to store and drain the detergent cup back into a bottle of All laundry detergent.
- Ocena
- 0 / 5
- Polubienia
- 42
- Pobrania
- 334
- Wydruki
- 1
- Wyświetlenia
- 1377
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a minor remix because the original did not fit my All detergent bottle. The outside diameter measured over the bottle threads is 37.5 mm on mine. I rounded off the sides, made the lip around the edge taller and reinforced the joint between the funnel and the pipe while I was modifying the model.
I had to print with a raft but no supports were required. The top is pretty steep when printing but the bridges are short, and its on the inside so was not a problem. Thanks to SteveS42 for including the Fusion 360 model which made this a quick edit. I actually like this other design better because it seals up the bottle using the cap to reduce evaporation:
https://www.printables.com/model/16713-laundry-detergent-cup-drain-new-tide-cup
But I printed this one and it works fine. If I had to print it again I would make the rim fit the cup closer though.