Laundry Detergent Cup Drainer
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A device to store and drain the detergent cup back into a bottle of All laundry detergent.
- Rating
- 0 / 5
- Likes
- 42
- Downloads
- 334
- Makes
- 1
- Views
- 1,377
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a minor remix because the original did not fit my All detergent bottle. The outside diameter measured over the bottle threads is 37.5 mm on mine. I rounded off the sides, made the lip around the edge taller and reinforced the joint between the funnel and the pipe while I was modifying the model.
I had to print with a raft but no supports were required. The top is pretty steep when printing but the bridges are short, and its on the inside so was not a problem. Thanks to SteveS42 for including the Fusion 360 model which made this a quick edit. I actually like this other design better because it seals up the bottle using the cap to reduce evaporation:
https://www.printables.com/model/16713-laundry-detergent-cup-drain-new-tide-cup
But I printed this one and it works fine. If I had to print it again I would make the rim fit the cup closer though.