1 / 7
Mitsubishi Outlander Charger Signal Cable Gland — zdjęcie 1
1 / 7

Mitsubishi Outlander Charger Signal Cable Gland

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Many used Outlander Chargers come without cable pigtails, with this gland you can replace it with a generic connector.

Ocena
0 / 5
Polubienia
7
Pobrania
21
Wydruki
0
Wyświetlenia
343
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution — Share Alike

Versions

  • M16: For small diameter cables as in the original application this gland is sufficient.
  • M20: This is the largest possible option.
  • Waipu SP21: If you want to replace the original connector with a 7- or 9-pin Waipu SP21 connector.

 

Recommended Material & Print Settings

  • 0.1mm Layer height for good thread resolution
  • The 1.5mm pitch thread can be tight if there is too much extrusion
  • The test prints were made with PLA, if you want to use it in a car better use ABS, PETG, …
  • The O-Ring groove usually does not need support if you have enough outer perimeters (at least on the layer above the groove) and print them from the inside out.

 

Additional Hardware

  • 1x 22.5x3 or 23x3mm O-Ring
  • 1x M16/M20 Cable Gland or Bulgin PX connector as shown in the pictures

For Waipu SP21 only:

  • 2x M3 heat set inserts
  • 2x M3x8 screws

 

Please consider liking the model and posting a Make. It took a lot of revisions and a lot of filament to get this right.

Tagi