1 / 7
Mitsubishi Outlander Charger Signal Cable Gland — image 1
1 / 7

Mitsubishi Outlander Charger Signal Cable Gland

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Many used Outlander Chargers come without cable pigtails, with this gland you can replace it with a generic connector.

Rating
0 / 5
Likes
7
Downloads
21
Makes
0
Views
343
Reviews
0

Updated at source:

Model information

Category
Automotive
License
Creative Commons — Attribution — Share Alike

Versions

  • M16: For small diameter cables as in the original application this gland is sufficient.
  • M20: This is the largest possible option.
  • Waipu SP21: If you want to replace the original connector with a 7- or 9-pin Waipu SP21 connector.

 

Recommended Material & Print Settings

  • 0.1mm Layer height for good thread resolution
  • The 1.5mm pitch thread can be tight if there is too much extrusion
  • The test prints were made with PLA, if you want to use it in a car better use ABS, PETG, …
  • The O-Ring groove usually does not need support if you have enough outer perimeters (at least on the layer above the groove) and print them from the inside out.

 

Additional Hardware

  • 1x 22.5x3 or 23x3mm O-Ring
  • 1x M16/M20 Cable Gland or Bulgin PX connector as shown in the pictures

For Waipu SP21 only:

  • 2x M3 heat set inserts
  • 2x M3x8 screws

 

Please consider liking the model and posting a Make. It took a lot of revisions and a lot of filament to get this right.

Tags