1 / 5
Mitsubishi Outlander Charger Power Cable Gland — zdjęcie 1
1 / 5

Mitsubishi Outlander Charger Power Cable Gland

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Many used Outlander Chargers come without cable pigtails, with this gland you can replace it with a generic connector.

Ocena
0 / 5
Polubienia
10
Pobrania
24
Wydruki
0
Wyświetlenia
585
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution — Share Alike

This is the cable gland for the 230V power input for the Outlander Charger.

 

Versions

  • With supports: The “skirt” enables a print without further support. If the perimeters are printed from the inside out, the O-Ring groove can be printed without supports as well.
  • Without supports: Add your own supports :)

 

Recommended Material & Print Settings

  • 0.1mm Layer height for good thread resolution
  • The 1.5mm pitch thread can be tight if there is too much extrusion
  • The test prints were made with PLA, if you want to use it in a car better use ABS, PETG, …
  • The O-Ring groove usually does not need support if you have enough outer perimeters (at least on the layer above the groove) and print them from the inside out.

 

Additional Hardware

  • 1x 16.5x2mm or 17x2mm O-Ring
  • 1x M20 Cable Gland

 

Please consider liking the model and posting a Make. It took a lot of revisions and a lot of filament and O-rings to get this right.

Tagi