1 / 5
Mitsubishi Outlander Charger Power Cable Gland — image 1
1 / 5

Mitsubishi Outlander Charger Power Cable Gland

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Many used Outlander Chargers come without cable pigtails, with this gland you can replace it with a generic connector.

Rating
0 / 5
Likes
10
Downloads
24
Makes
0
Views
585
Reviews
0

Updated at source:

Model information

Category
Automotive
License
Creative Commons — Attribution — Share Alike

This is the cable gland for the 230V power input for the Outlander Charger.

 

Versions

  • With supports: The “skirt” enables a print without further support. If the perimeters are printed from the inside out, the O-Ring groove can be printed without supports as well.
  • Without supports: Add your own supports :)

 

Recommended Material & Print Settings

  • 0.1mm Layer height for good thread resolution
  • The 1.5mm pitch thread can be tight if there is too much extrusion
  • The test prints were made with PLA, if you want to use it in a car better use ABS, PETG, …
  • The O-Ring groove usually does not need support if you have enough outer perimeters (at least on the layer above the groove) and print them from the inside out.

 

Additional Hardware

  • 1x 16.5x2mm or 17x2mm O-Ring
  • 1x M20 Cable Gland

 

Please consider liking the model and posting a Make. It took a lot of revisions and a lot of filament and O-rings to get this right.

Tags