1 / 10
3 Bay 2.5in HDD/SSD Hot Swap Cage Chassis 5.25in Drive Tray — zdjęcie 1
1 / 10

3 Bay 2.5in HDD/SSD Hot Swap Cage Chassis 5.25in Drive Tray

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Hot Swap 5.25in Drive Tray

Ocena
5 / 5
Polubienia
34
Pobrania
112
Wydruki
1
Wyświetlenia
3880
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Noncommercial

 

!!! Disclaimer !!!

It came to my attention that HDDs can reach temps up to 60°C (140°F) degrees.  

The design has no active ventilation, that means you might damage drives due to heat, so be careful, and accept the risk if you decided to use it.

This also means that this model should be printed with PETG (or more heat-resistant plastic) to not get softened plastic in higher heat situations. 

 

Parts needed:

  • 7 x M3 ~30 mm screws 
  • 7 x M3 nuts
  • 3 x SATA 22 Pin 7+15 Pin Male Plug To SATA 22P 7+15P Female Jack
  • 4 x M3 brass insert
  • 9 x M2 brass insert
  • 9 x M2 13 mm screws
  • 3 x M2.5 8 mm Cylindrical Dowel Pins

Let's hope I didn't forget anything :) 

Use supports on obvious places, also I was using PLA for body and PETG for drawers, however I think it does not matter for any of the part.

I am printing with 100.5% scale to compensate plastic shrinkage - the drives fit perfectly

Tagi