3 Bay 2.5in HDD/SSD Hot Swap Cage Chassis 5.25in Drive Tray
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Hot Swap 5.25in Drive Tray
- Rating
- 5 / 5
- Likes
- 34
- Downloads
- 112
- Makes
- 1
- Views
- 3,880
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial
!!! Disclaimer !!!
It came to my attention that HDDs can reach temps up to 60°C (140°F) degrees.
The design has no active ventilation, that means you might damage drives due to heat, so be careful, and accept the risk if you decided to use it.
This also means that this model should be printed with PETG (or more heat-resistant plastic) to not get softened plastic in higher heat situations.
Parts needed:
- 7 x M3 ~30 mm screws
- 7 x M3 nuts
- 3 x SATA 22 Pin 7+15 Pin Male Plug To SATA 22P 7+15P Female Jack
- 4 x M3 brass insert
- 9 x M2 brass insert
- 9 x M2 13 mm screws
- 3 x M2.5 8 mm Cylindrical Dowel Pins
Let's hope I didn't forget anything :)
Use supports on obvious places, also I was using PLA for body and PETG for drawers, however I think it does not matter for any of the part.
I am printing with 100.5% scale to compensate plastic shrinkage - the drives fit perfectly