SV06 Gyro Filament Guide and Cleaner

***Uploaded new version with a little more reinforcement on the hooks and a little greater tolerance to help with install***

***Fixed Issue where part of the gyros polls were not loading into the slicer and the cleaning tube being closed on top****

I made this model almost solely on prusa slicer because iv yet to find software to properly edit an stl even with solid works. But either way this model was cut out of three other models and rudely spliced together, then opened in tinker cad to remove the areas I had in prusa slicer That wont travel when exporting to STL. I cant upload any G-Code files because I use arc-welder to compress and smooth out circles using arc moves instead of straight lines,,, this prusa didn't like and will not let me upload them, the .3mf file is my V4 prototype the one in the photo before exporting to tinker-cad. 

V2 gyro and V4 ARM was what I have pictured, I do have an edited model more ready for print in place with fewer supports, however I haven't tested it (let me know if you do!). All files Will need minor supports in some areas paint on supports around mechanical bridges.

Recommend using cotton or small pieces of sponge in the capsule to make your life easier on filament switches. the cap holds every thing in and can be put on and off while filament is loaded.

I Printed most of these between 1.2 and 1.8 using overture PLA+ on my Sovol SV06, with 10-15% grid infill.    ****Highly recommend adding a modifier on the clip section and change infill to 99% Concentric to help with the strength of the clip******

Video can be seen here on the Sovol SV06 Facebook page:

https://www.facebook.com/groups/sovolsv06usergroup/permalink/773103630800249/