MGA/MGB Gearbox and Rear Axle Breather Vent
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Rear axle/gearbox vent for MGA, early MGB, and possibly other cars produced by British Motor Corporation.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 55
- Wydruki
- 0
- Wyświetlenia
- 654
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
Originally this part was made of steel, then at some point they switched to a plastic unit of nearly the same dimensions. For some decades, if you try to order a replacement you will get a part used on the late MGB, which looks nothing like either version of the originals, and which may not even fit under the transmission tunnel. The steel originals hold up pretty well, except BMC foolishly put a screwdriver slot in them, which leads to the slot getting all chewed up when removal is attempted.
Looking at how the steel part was made, there are several lathe operations involved, a couple of milling operations, and then the outer sleeve is brazed in place. Given the expense involved in duplicating that, and that you're only ever going to see the vent when working on the car, we'll likely never see a proper reproduction of this part made available. I don't actually need one myself (I have steel originals in good shape), but reverse engineering it for 3D printing seemed like a worthwhile project, so here it is. It's obviously not going to fool anybody who looks at it closely into thinking it's an original part, but what were they doing under your car in the first place? In the photo with multiple parts, the two on the left are steel originals for comparison.
First, do not attempt to install this with a screwdriver; the slot is purely cosmetic. This damages the original steel breather, so you should not expect a 3D printed plastic version to fare any better. I was able to turn it into the threads by hand due to the reduced shank, but you could try a soft jawed pliers too if you are feeling lucky. Alternately, one could run a 1/8 BSPP die over the shank, but I did not find this to be necessary.
Second, no PLA or PETG. The ones pictured were printed out of Polymaker ABS, which MIGHT have enough heat resistance, but if you are going to use these it would be best to print them out of nylon. Third, use a decent number of perimeters when you slice this. Due to the nature of the part there isn't going to be much if any infill. Print multiple copies even if you only need one, this will increase the time to print each layer, which will enhance the part cooling.
Fourth, use at you own risk. This doesn't have any provision for a check valve, and really it's only a splash guard for the vent hole in the housing, just like the originals. Probably nobody these days is going to drive their MG through water or mud deep enough for that to be an issue (unless maybe you are Barney/MGAGURU).
I printed this in Polymaker ABS on a Voron 2.4, using a 0.4mm nozzle and 0.2mm layer height.
More information on MGA axle/gearbox breathers from Barney Gaylord's website:
https://mgaguru.com/mgtech/gearbox/gt119.htm