Fox Fork Air and Rebound Cap Tool
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
wrench/socket I made to fit the air and rebound caps on my fox 38. probably works for other fox forks aswell.
- Ocena
- 5 / 5
- Polubienia
- 39
- Pobrania
- 621
- Wydruki
- 10
- Wyświetlenia
- 2157
- Oceny
- 7
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
I came up with this after getting my fork back from the shop for a rebuild. the cap covering the rebound knobs was put on a little too tightly, and was covered in oil from the service, making it nearly impossible to get off, which is why I made this thing.
This also happens to be the only tool I know of that fits the rebound knob cap. Which means that if you torque down your buddies rebound cap, they have no way of getting it off without this specific tool. Do what you will with this information…
probably works for other fox forks aswell, however I've only tested it on my 38, and a friend's fox 40. it worked for both, so it might work for other fox forks aswell.
for print settings, use a few more walls than normal, at a decently high infill ~50 percent
no supports needed