1 / 3
Micro Swiss NG BL Touch Fan Shroud For Ender 6 — zdjęcie 1
1 / 3

Micro Swiss NG BL Touch Fan Shroud For Ender 6

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

The Ender 6 version of Micro Swill NG Direct Drive doesn't come with a BL touch mount

Ocena
5 / 5
Polubienia
21
Pobrania
177
Wydruki
1
Wyświetlenia
1555
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Public Domain

The Micro Swiss NG direct drive doesn't come with a BL Touch mount. There isn't much room to allow for one. When the Ender 6 prepares to print, the print head moves to the left front corner of the print surface. A BL Touch mounted conventionally would crash into the belt pulley bracket. I turned the BL touch ¼ turn and added a mount to the fan shroud that hods it from the bottom. The BL covers the fan shroud's left hand mounting screw so it needs to be dropped in and set up after mounting the shroud. I'm not sure how to edit the offset position because the Ender6 doesn't have open firmware. This still helps level the bed just not as precisely as it would if the BL's new location was set. The screw hole is a bit small 2.5mm Print with support on build plate only.

Tagi