1 / 2
75mm VESA pegboard mount (fixed)
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix of the 75mm VESA pegboard mount from nmavor
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 105
- Wydruki
- 0
- Wyświetlenia
- 582
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution
SzczegółyPliki (1)Wydruki i komentarze (Wydruki: 0) (Komentarze: 1)Remiksy (0)Kolekcje (19)Powiązane
This is the same base model from nmavor, but with the following changes:
- Geometry around the base of two angled pegs were not closed leading to holes in the model when sliced. These were patched.
- Corners were rounded to help prevent lifted corners during print.
- Outside edges were chamfered 45 degrees.
Since it is not stated in the original model page, I recommend printing upright as provided with the following settings:
- Layer height: 0.2mm
- Line width: 0.4mm
- To keep the pegs clean:
- Support line width: 0.2mm
- Support interface line width: 0.15mm
- Wall line count: 4
- Infill density: 80%
- Use a 5mm brim
I used support blockers on the mounting holes as they're small enough to print without supports.