1 / 2
75mm VESA pegboard mount (fixed)
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Remix of the 75mm VESA pegboard mount from nmavor
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 106
- Makes
- 0
- Views
- 585
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution
This is the same base model from nmavor, but with the following changes:
- Geometry around the base of two angled pegs were not closed leading to holes in the model when sliced. These were patched.
- Corners were rounded to help prevent lifted corners during print.
- Outside edges were chamfered 45 degrees.
Since it is not stated in the original model page, I recommend printing upright as provided with the following settings:
- Layer height: 0.2mm
- Line width: 0.4mm
- To keep the pegs clean:
- Support line width: 0.2mm
- Support interface line width: 0.15mm
- Wall line count: 4
- Infill density: 80%
- Use a 5mm brim
I used support blockers on the mounting holes as they're small enough to print without supports.