1 / 2
Hanging lamp — zdjęcie 1
1 / 2

Hanging lamp

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

hanging lamp with a detachable, magnetic lampshade

Ocena
5 / 5
Polubienia
395
Pobrania
1132
Wydruki
5
Wyświetlenia
8045
Oceny
7

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Home Decor
Licencja
Creative Commons — Attribution — Noncommercial

Inspired by a 3D printed hanging lamp I saw, I designed this lamp shade with a magnetic base.

I plan on designing some other lamp shade designs in the future. I will also upload .step files so anyone can modify them to their liking and add new shade designs.

The base uses a standard E27 cable / mount.

24.04.23: Uploaded correct bulb mount.

29.06.23: I realized that i uploaded the wrong size for the lamp shade, I uploaded the correct one (as seen in the pictures); I'm very sorry for the mistake. I also added the Fusion File and the step file to create your own.

BOM:

  • 10x 6x3 neodym magnets (I used N45, but weaker ones should work too)
  • Super glue
  • Cable and mount for E27 lamps
  • E27 lightbulb

Print instructions

  • Print the lamp shade in vase mode (I used a forced width of 0.7 mm on a 0.4 nozzle to make it more rigid)
  • Print the other parts however you like, no ironing needed if printed as is.

Assembly

  • Glue or insert the magnets into the holes of the ring and the base (I used some glue to fixate them, the holes are not pressfit).
  • Glue the ring to the inside of the lampshade.
  • Let the glue dry and then install the E27 cable in the base.
  • Screw in the lightbulb
  • Install the whole assembly

 

Instructions for Fusion File

  • Move the slider back between the third and sixth step (I normally use between 3 and 4)
  • Draw whatever you want, create your shapes, etc. (Important to do this between the specified steps)
  • After you're done, move the slider to the end to hollow it out and get the magnet base
  • Done!

The .step file is already “done”, so it is hollowed out and everything, you will have to find a way to add your design on the outside

Tagi