1 / 7
Slot cover for Tukkari TLX MK3S+MMU2S enclosure — zdjęcie 1
1 / 7

Slot cover for Tukkari TLX MK3S+MMU2S enclosure

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Covers the slot in the top face of the Tukkari TLX MK3S+MMU2S enclosure, allowing one of the MMU2S feeds to be…

Ocena
5 / 5
Polubienia
12
Pobrania
73
Wydruki
1
Wyświetlenia
1093
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution

Covers the slot in the top face of the Tukkari TLX MK3S+MMU2S enclosure, allowing one of the MMU2S feeds to be accessed from the top of the enclosure. I have a dry box holding the four filaments which I use most often, and I use the 5th feed for whatever filament I need for other purposes. In the photos I'm using the spool holder that comes with the Tukkari enclosure. The slot cover also serves to seal the slot, keeping dust out and heat/fumes in.

There are two versions - one is designed to have 5mm wide by 1mm thick adhesive foam seal tape gasket applied to the mating surface (see photos) - this has a delightfully snug fit. The "no gasket" version is designed to used as-is, but will not be so snug.

Print instructions

PETG, or anything that will withstand the temperatures at which you run your enclosure. I used 0.3mm DRAFT, 3 perimeters, 20% infill.

The hole for the PTFE tube is just right for the original Prusa PTFE tube in my setup, and as printed on my printer - snug but not tight. If your print is too tight, you could dress the hole with a 4mm drill bit.

Tagi