Voron Trident-R1 MGN12H rear Z carrier
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Gives you the option to use a MGN12H rail for the rear Z assembly rather than the stock MGN9H
- Ocena
- 0 / 5
- Polubienia
- 62
- Pobrania
- 254
- Wydruki
- 0
- Wyświetlenia
- 2301
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- GNU General Public License v3.0
MGN12H rear Z carrier for Trident-R1
CHANGELOG
01.05.2023: WobbleX - Opened up the center hole (where the leadscrew goes through) too 13mm to allow for more leadscrew movement without interfering witht he carrier body.
25.04.2023: Variable pin sizes for WobbleX carriers, since it's been some issues with the pin sizes being either too small or large I've made a little test model so you can determine what suits you best. When you've found the right size for you then you choose the corresponding set of carriers.
15.04.2023: WobbleX v1.7, resized the pin holes too 2.9mm (the old/stock was 3.1mm and the pins would be loose and fall out).
15.04.2023: WobbleX v1.6, added recess for the WobbleX balls (missing in stock/MGN9H release too).
11.04.2023: Counterbore fix for all carriages & WobbleX v1.5.
11.04.2023: WobbleX v1.
30.11.2022: Initial release.
MGN12H rear Z carrier for Trident
Printing:
Default voron settings, correct orientation, no supports needed!
Bom:
For "standard" carriers:
Same as stock Trident except a MGN12H rail set.
For WobbleX carriers:
1x WobbleX WS8
1x MGN12H rail set
Stock Voron Trident screws etc.
Description:
Modifed Voron Triden r1 rear Z carrier to house a MGN12H block instead of MGN9H.
One version for IGUS chains (2bolt), and one version for the generic Chinese ones (3bolt).
Rail stop that's been sized to accommodate for a MGN12 rail.
WobbleX implementation.
You will loose a tiny bit of Z travel, otherwise it's not much to "negative" (quite substantial loss of Z travel with WobbleX, but that's not isolated to this mod, it's just the nature of the beast).
Pictures:
WobleX version:

10.5mm(old) vs 13mm(new)

- - -
In case I forget to upload any eventual updates i make to the design to Printables, the latest released version should always be avalible on my gitub!