UNO Multicolored Card Box
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This UNO Card Box with multicolored logo is based on the UNO Card Box by Markus_p.
The 3MF file of the lid also contains the parts needed for the logo. PrusaSlicer opens this just fine, I don't know about other slicers. Use a pause/filament change/M600 command for color swapping for the first layer. Make sure your first layer height is 0.2mm, otherwise you must also swap colors on the second layer.
Check the comments for a detailed print guide made by lost_371113. (Using PrusaSlicer and a single extruder).
The inner card holder could be glued in place. Note that the beveled side should be at the front.
The box will not close properly if the card holder is glued the other way around. Test before gluing.
For the hinges you will need 6x additional M3x30mm screws.
Filament used:
- SUNLU PLA Marble (I think it has small pieces of rock in it, so not the best for your nozzle.. But it looks great!)
- RepRapFilament PLA Yellow
- RepRapFilament PLA Red
- Some random black PLA