E-Gaita: Electronic 3-holed Flute
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Electronic 3-holed flute from Salamanca (Spain)
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 26
- Wydruki
- 0
- Wyświetlenia
- 521
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Music
- Licencja
- Creative Commons — Attribution — Noncommercial
Electronic 3-holed pipe from Salamanca (Spain). The model is splitted in 6 pieces. It leaves space for electronics. The joints of the pieces are made with screws (see schematics on pictures).
Real Prototype Showcase: https://youtube.com/shorts/tJq8Ec82kSM
List of guts
- 8u. — 5x3mm screws (6 for joints + 2 for holes)
- 2u. — 4x2.5mm screws (for semitone holes)
- 1u. — MPR121 capacitive sensor
- 1u. — WeMos D1 mini mother boarding and device connection
- 1u. — MPX5010GP windflow sensor
- Xu. — Wires as you need for all connections
- ?u. — Battery as your election. It works even with no battery (USB power-supply)
More Details
It's recommended to use 3mm screws for the bigger holes and 2.5mm for the smaller holes (this smaller ones perform as a pair so you can control semitones, like if you are just covering one half of the hole), all connected to a capacitor sensor. It also leaves room for mainboard and output with USB wire used for alimentation. Blowing is controled with a pressure sensor in the mouthpiece. There are extra printable rings for covering the joints in case you want to hide them on a clean way. You can see here the electronics scheme:
Also here is how extra blowing will be extract out of the instrument, so it does not go back to your mouth after reaching the MPX5010GP connection (No cyclic blowing):
About the software: it is on a primal prototype version. If you are interested right now, you can md me, but I'll wait to improve it before uploading it publicly. It will also be accompanied with a mobile/pc application where you'll be able to change tone, notes range, pitch or even regulate air sensibility. You can record a song, and send it to groups, and on the future there'll be features to practice that records (just like “guitar hero” style).
Future steps
I want to make a refactor of all the electronics, fitting all properly and saving space. So, in the future, I want to re-adapt the design of the flute, but these are all brainstorming ideas. Putting it all in a nutshell:
- Electronics → PCB
- Fitting 3D design to new electronics PCB
- Holes are real holes → capacitor is in the border of the hole ring (clean & user-known design)
Thanks for reading!! I hope you enjoyed discovering the E-Gaita!!