Drone holder for Ikea Skadis
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Drone / quadcopter holder for Ikea Skadis using the T-Nuts system
- Ocena
- 5 / 5
- Polubienia
- 17
- Pobrania
- 83
- Wydruki
- 2
- Wyświetlenia
- 833
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
As this is one of my first quads I just can't have this one laying in the corner. I used this holder before with command tape, but it fell off the wall (hence the broken prop). So I thought why not remix it a bit and use the t-nuts system again.
Made it a bit thicker so the hardware I have fits. Cleaned the model up after importing and rounded the corners a bit to make it easier to stick on the build plate.
Hardware needed:
- 2x DIN 7985 TX (M2.5 x 12)
- 2x M2.5 nut (found here)
Print settings:
I used the default PrusaSlicer settings: 0.20mm 100mms linear advance. Printed with Prusament PLA in the color Galaxy black.
Print details:
Model size: 124.77mm × 121.88mm × 25.00mm
Filament: 6.13m / 14.74cm³
Estimated print time: 01:12:24
Last print time: 01:12:17