XXL Spool Holder (5kg & Under)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An oversized spool holder for xxl sized spools. Nothing too fancy.
- Ocena
- 4,5 / 5
- Polubienia
- 25
- Pobrania
- 274
- Wydruki
- 1
- Wyświetlenia
- 1413
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- GNU General Public License v3.0
An oversized spool holder for xxl sized spools. Nothing too fancy.
Doesn't feature any type of bearings, or fancy features. I needed a plain and simple spool holder for Polymaker's 5kg abs spools, and threw this design together in F360. The added benefit of printing such a large spool holder is it fits anything smaller than 5kg, too!
Due to a little bit of an oversight on my end: the brace pieces have a top and bottom side due to the screw holes needing to line up. They will only screw in if they're facing the right direction. The correct orientation is to have the holes closer to the top.
You will need to print:
- 5kgSpoolHolder_Brace (x3) (2 will also work)
- 5kgSpoolHolder_Frame (x2)
- 5kgSpoolHolder_Holder (x1)
You will also need:
- M3x5x4 heat-set inserts (x6) [heatsets from DFH here]
- M3x20 screws (x6) [your preference on head type]
Instructions
- Insert heat-sets into the brace pieces. One on each side
- Screw the frame into the brace
- Enjoy!
Print recommendations:
- 15% gyroid infill
- .3 layer height
Maybe in the future I'll look into a design that adds bearings.