Cable Management Clips

I need to organize the cables under and behind my computer desk, so I decided to design these in F360. They are “over-engineered” in the sense that they each require two m3x8 screws and 2 m3x5x4 heat-set inserts. 

I designed these to use some vhb tape to the back of my desk, which is why one has a pattern and the backside is flat.

You will also need:

• vhb tape
• 2x m3x5x4 heat-set inserts [heatsets from DFH here]
• 2x m3x8 screws

or

• vhb tape
• 4x m3x5x4 heat-set inserts
• 4x m3x8 screws

the heatsets listed are the exact ones this is designed around.
Recommended Print Settings:

• 100% Infill
• .2 layer height
• Slower is better

Instructions

1. Print
2. Insert 2x heatset inserts into the bottom piece.
3. Use some vhb-tape to adhere them to your desk.
4. Run your cables, and clunkly manage to screw in two m3x8 screws to seal the deal
5. Enjoy