Ender 3 S1 Pro mainboard and PSU 60x25mm fan mounts
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Offsets the fans to provide enough clearance to replace the two 60x15mm fans with 60x25 fans
- Ocena
- 5 / 5
- Polubienia
- 34
- Pobrania
- 98
- Wydruki
- 1
- Wyświetlenia
- 1718
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
The mainboard / motherboard fan mount is 6mm high and can be installed with the standard printer feet.
The PSU fan mount is 11mm high and requires higher printer feet (I used these).
Installing the fans requires cutting holes inside the backplate (with a dremel or jigsaw).
You can fix the fan mounts by either:
- tapping holes on the backplate and screwing M3 screws on the mount corners
- drilling holes on the backplate and screwing into the fan mount smaller holes
If you want to use 12v fans like noctua fans, you will need a step-down converter, like a MP1584.
Warning: the PSU contains dangerous capacitors that can shock you. Be very careful if you want to mod the PSU fan.