Prusa MK3 Lazy Susan Spool
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
When printing soft or flexible filaments, even the slightest resistance in the spool holder can cause unpredictable…
- Ocena
- 5 / 5
- Polubienia
- 24
- Pobrania
- 52
- Wydruki
- 1
- Wyświetlenia
- 474
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Share Alike
When printing soft or flexible filaments, even the slightest resistance in the spool holder can cause unpredictable tension/stretching in the filament feed, leading to irregular prints. This spool holder for the Prusa MK3 frame uses a single 608 bearing to minimize feed resistance.
Drop the bearing into the hat & push down firmly to seat. Drop an M8 nut into the bottom of the axis & get it close to seated, then insert an M8 screw thru the top of the bearing/hat assembly & screw it into the nut until firm. Give it a test spin. Giggle and spin it again. Hook it onto the frame, hook the guide on next to it, then drop a roll of filament onto it.
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
25%
Filament: Matterhackers PLA White
Notes:
Supports are only necessary for the hat, which I would recommend printing flat. Print the other 2 on their flat sides, so the print is drawing the profile of the "hook" on each layer.
Category: 3D Printer Accessories