KP3S Pro Heatbed cable strain relief, angled
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Strain relief for the KP3S Pro heatbed cable, angled at 90 degrees
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 327
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The KP3S Pro really needs a strain relief, and the model made by LMaker is really good. It sticks out a little too far behind the bed for my use case though (my printer cabinet is very small), so I made a version that angles the cable 90 degrees towards the cantilever profile.
In order to make sure that the cable collector doesn't stick out too much towards the back either, I used a slightly longer M3 screw, with a nut in the end, for one side of the cover and tightened down the cable collector against this with a zip tie (see photo).
Printed in PLA with 0.3 mm layer height, 100% infill and later “annealed” to make it more temperature resistant (can withstand 110+ degrees C without issue).